Incense Making Logo

Incense-Making.com  
Step by Step Guides to Natural Incense Making   

FREE Incense
Making Newsletter

 
 
 

 
Prepare A Kodo Cup

How to Prepare a Kodo Cup
 

1

A Kodo cup and another burner for starting the charcoal are needed. Fill the Kodo cup almost full with clean white chaff ash.

Note: a Kodo cup is also known as a Kiki-gouro

2

Heat a large bamboo charcoal in a separate bowl of ash until it is completely red-hot and grayish-white.

Note: A separate bowl called a Hitori-gouro is used to start the charcoal because initially the charcoal gives off a subtle unpleasant scent that you do not want to be absorbed by the ash in your kodo cup.

Hitori Gouro

3

Fluff the Kodo cup ash so that it's not compacted and create a small hole in the center to accept the charcoal.

4

Place the charcoal in the center of the cup so it sets just slightly lower than the surface of the ash.

5

Use the chopsticks to pull the ash up into a mound over the charcoal.

6

Using the ash press or a butter knife, lightly tamp and compress the ash mound into a smooth volcano shape over the charcoal.

7

Rotate the bowl and continue to press until smooth.

8

With a metal chopstick, gently make an air-hole to the charcoal and push the charcoal down just slightly. The charcoal should be about 1/2 inch below the surface.

Optionally, you can decorate the surface with traditional lines (see books on Kodo).

9

If you have a feather, it's used now to clean the ash from the edge of the cup.

10

Place the mica plate gently on top of the air-hole and press it down softly to secure the mica in place and keep it level.

11


Place a piece of aloeswood or sandalwood on the mica plate.

Note: Aloeswood pieces should be about the size of a single grain of rice.
 

The raw materials should not smoke, but rather slowly release their wonderful aromas through low heat. Resins in the wood may visibly bubble.

Troubleshooting:

If the charcoal is buried too low the mica may not get warm enough to release the woods' fragrance. In this case, remove the mica plate, fluff the ash, and bring the charcoal up higher and begin again. Also, if the ash is old and used, it may not let the charcoal breathe and force it to extinguish itself. Always use clean ash for Kodo.

If the charcoal is too high and therefore too close to the mica plate, it will generate too much heat and may smoke the wood. This is remedied by either adding a second mica plate to diffuse the heat, or by removing the mica plate and using a chopstick through the hole to push the charcoal further down.

Back to Top